Gator Rigging is an authorized Van Beest & CM distributor. We have a large inventory of wire rope clips. For more information about our wire rope clips, please see the information below.
Proper use of Wire Rope Clips
- Refer to the chart above in following these instructions. Turn back specified amount of rope from thimble or loop. Apply first clip one base width from dead end of rope. Apply U-bolt over dead end of wire rope - live end rests in saddle. Tighten nuts evenly, alternate from one nut to the other until reaching the recommended torque.
- When two clips are required, apply the second clip as near the thimble or loop as possible. Tighten nuts evenly, alternating until reaching the recommended torque. When more than two clips are required, apply the second clip as near the loop or thimble as possible, turn nuts on second clip firmly, but do not tighten. Proceed to Step 3.
- When three or more clips are required, space additional clips equally between the first two - take up rope slack - tighten nuts on each U-bolt evenly, alternating from one nut to the other until reaching the recommended torque.
- Apply an initial load equal to loads expected in use. Inspect for proper orientation and spacing of clips and re-tighten the nuts to recommended torque.
Gator Rigging is an authorized CM and Yoke distributor. We have a large inventory of hooks. In addition to standard rigging hooks, Gator Rigging can custom fabricate ROV hooks. For more information about our hooks, please see the information below.
Gator Rigging is an authorized CM and Yoke Distributor. We also carry the Van Beest line of shackles. We have a large inventory of screw pin and bolt type shackles.
Click on the links below for more information about our shackles: